![]() ![]() ![]() Guard Part #: 9896-4030 Hanger Part #: 9895-4021 Q/R Axle Guard Spacer Guard Q/R Nut 31 25 10 GUARD PINS Long (31mm): All SRAM derailleurs All Shimano Shadow derailleurs Medium (25mm): Shimano XTR / XT / LX (All Shimano derailleurs with countersunk hanger bolt) Short (10mm): (All Shimano derailleurs without countersunk hanger bolt) Derailleur Guard Installation (Q/R option): 1. The guard works with solid or Q/R axle types and is compatible with all Mountain bike models using the 2005-2006 Enduro/Demo derailleur hanger. Please refer to your shock owner’s manual for additonal setup information. Note - the chart is only a starting point, actual sag needs to the checked and adjusted on the bike, while riding, and at regular intervals. ![]() Refer to chart below for specific weight settings. Typically a slower rebound for slow speed, bigger hits to eliminate kickback, or faster rebound for higher speeds and smaller hits, so the suspension does not dive and has time to rebound between bumps. RP23: When the ProPedal is engaged, there are three settings to adjust firmness: 1) Light - Technical rough trails 2) Medium - Meandering trails, flats 3 Firm - Uphill, pavement SETTING REBOUND Set rebound damping adjuster to rider preference. SETTING PROPEDAL The ProPedal adjustment has two lever positions, on or off. After setting the pressure, push the rubber ring up to the seal, sit on the bike gently, dismount, and measure sag. Recommended sag: 11.5-17mm of stroke See attached chart for starting air pressure. FOX RP23 / RP2 REAR SHOCK SETUP SETTING SAG Set the sag at 20 to 30% of shock stroke. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |